DOOR EDGE PROTECTOR 5/8″ (16MM)

1. Wash your hands thoroughly before use, avoiding dirt & skin oil marks on the product.
2. Clean the door edge (both the interior and exterior surfaces) using RHINOMOTIVE R1845 microfibre towel. Apply only to a clean surface free of wax, grease, and dirt, between 13°C – 32°C.
3. Always check part position, shape and size before applying.
4. Start to remove one strip from the paper. Do not pull the entire strip off the paper as the adhesive can become contaminated.
5. Beginning at the top, press the film onto the door’s exterior surface so that half of the film width is on the outside door edge, and half is extending beyond the door edge.
6. Continue this process down the door edge to the bottom of the film. Trim at the bottom as necessary with scissors or razor blade.
7. Begin pressing the film around the edge of the door over the entire length of the door, but not all the way to the back side yet. This will help to prevent air bubbles.
8. After starting to secure the edge, continue to fold the film around to the back of the door edge over the entire length of the door.
9. Remove all air bubbles by smoothing with moderate finger pressure.

TECHNICAL SPECIFICATIONS

• Roll Width: 5/8 in | 16 mm
• Roll Length: 100 ft | 30.5 m
• MADE IN USA